Batteries
Tessonics Corporation has made every effort to ensure the accuracy and completeness of this document; however, because ongoing efforts are made to continually improve the capabilities of our products, we cannot guarantee the accuracy of the contents of this document. We disclaim liability for errors, omissions, or future changes herein.
Tessonics Corporation and its subsidiaries reserve the right to make changes, corrections, enhancements, modifications and improvements to its products and/or to this document at any time without notice.
Information in this document supersedes and replaces information previously supplied in any prior versions of this document.
Tessonics and the Tessonics logo are trademarks of Tessonics Corporation.
All other trademarks mentioned herein are the property of their respective owners.
©2007–2024 Tessonics Corporation. All rights reserved.
No part of this document may be copied, reproduced, or translated, without the prior written consent of Tessonics Corporation.
The device comes with two removable battery packs. It can operate from either or both of these batteries as well as directly from the AC adapter.
The remaining battery life can be checked both on the device, using the power manager, as well as with the power meter located on the bottom of the battery itself. The power meter has five squares and is always active. It will display the relative battery level by displaying or hiding any of these 5 squares.
# Squares | Battery Level |
---|---|
0 / 5 | Dead Battery |
1 / 5 | 1% - 20% |
2 / 5 | 21% - 40% |
3 / 5 | 41% - 60% |
4 / 5 | 61% - 80% |
5 / 5 | 81% - 100% |
Battery Charging
When the device is connected to an AC adapter, any inserted batteries will automatically begin to recharge. While the batteries are charging, the Battery Charge icon on the Indicator panel will be active after 6-12 seconds. When the batteries are fully charged, the Battery Charge icon will turn off.
Note
When not in use for a month or more, fully charge the battery prior to storing.When RSWA is turned off, a fully discharged battery will take about 3 hours to recharge. If RSWA is turned on and is not in suspend mode, it will take about 4-5 hours to recharge the battery.
When to Replace the Battery
Over time, the batteries’ capacity gradually decreases. It is recommended that the batteries be replaced when they begin to store significantly less charge. Only use replacement batteries approved by Tessonics. The use of unapproved batteries may cause damage to the device and void the warranty.