Remote
Tessonics Corporation has made every effort to ensure the accuracy and completeness of this document; however, because ongoing efforts are made to continually improve the capabilities of our products, we cannot guarantee the accuracy of the contents of this document. We disclaim liability for errors, omissions, or future changes herein.
Tessonics Corporation and its subsidiaries reserve the right to make changes, corrections, enhancements, modifications and improvements to its products and/or to this document at any time without notice.
Information in this document supersedes and replaces information previously supplied in any prior versions of this document.
Tessonics and the Tessonics logo are trademarks of Tessonics Corporation.
All other trademarks mentioned herein are the property of their respective owners.
©2007–2024 Tessonics Corporation. All rights reserved.
No part of this document may be copied, reproduced, or translated, without the prior written consent of Tessonics Corporation.
A remote is supplied with the unit and allows for operation of the device wirelessly. Once the software has been initialized, the remote allows the operator to perform common tasks including probe setup and getting /images. When not in use, the remote is stored in a specialized holder on the back on the device.
Button Assignments
{height=35% options=right}
- or
- Perform Setup or Get routine for taking a measurement
- or
- Increase/decrease the diameter of the manual circle
- or
- Make a decision on weld quality
-
- Move to next weld or unit
-
- Exit from menu or dialog
-
- Confirm selection in menus and dialogs
- or
- Up and down cursor keys; in Array Explorer’s main window: Navigate up and down in the weld list view
- or
- Left and right cursor keys; in Array Explorer’s main window: Navigate left and right in recent measurements
-
- Opens drop down menu in A-scan view
-
- Toggles between front and back cells in weld list view
-
- Toggles between automatic and manual circle measurements
Pairing
The pairing procedure will set up the receiver to be controlled by a specific remote. In the environment with multiple RSWA units and remotes, this allows the user to choose specifically which remote controls which RSWA.
To pair the remote control with the receiver:
- Make sure the receiver is plugged into the RSWA and that RSWA is running
- Bring the remote within a few inches from the receiver located above the screen, push and hold any button on the remote for 5 seconds. The LED on the remote will flash rapidly during the pairing procedure;
- Release the button and test the remote with RSWA applications.
If you need to pair a remote to a different RSWA, remove the battery from the remote for about 1 minute. This will reset it to the original unpaired state. Then put the battery back and repeat the pairing procedure with the different receiver.
Replacing the Battery
This remote needs a battery to operate. Replace the battery when needed with CR2025 battery.
{min-width=50%}
To replace the battery:
- Pull the battery compartment out and remove the old battery
- Insert the replacement battery with the positive side facing up
- Close the battery compartment
- If necessary, perform the pairing procedure